Recently the small chassis has become more and more popular, ITX hardware prices are still a little expensive, MATX whether it is a motherboard or chassis with a lot of cost-effective products can choose, this time finally set up a MATX water-cooled host wish to complete.
Let's take a look at the chassis first: Xingu Aurora Blade Chassis
Xingu Aurora Blade's frontal appearance is still very conspicuous. There is a large area of ​​metal dustproof net cover on the front panel and the top inside, and the outside is designed with transparent acrylic. This mix and match combination is still very sci-fi sense, and also enhances the chassis. External personality.
Aurora has a total of two colors, Aurora Black and Aurora White. I chose Aurora White this time.
On the other side, the side panels use a raised design to make room for the back line.
Chassis size, fan, and hard disk support
The I/O interface consists of a USB 3.0, two USB 2.0, a set of 3.5mm audio output/input interfaces, and power and reset keys.
Front and rear view: The chassis has four PCI slots and a 120mm cooling fan on the back.
The bottom of the power supply inlet with a dust-proof net design, material should be PVC; bottom tripod is also considered high, the following is affixed with anti-skid rubber.
Officially introduced the highest support 163mm tower radiator and 330mm long high-end graphics card, compatibility is good.
Due to the price, the baffle section only has one reusable baffle, the power supply compartment is separated, the partition of the power supply compartment has some holes for the wiring, and the installation of a 2.5-inch hard disk is also supported.
The back also supports 2.5-inch hard disk mounting position; the back of the wiring hole is more, the cable is still very convenient; CPU hole retention area is still relatively large, for most motherboards, you can first install the motherboard on the chassis , and then install the radiator.
The downside is that the space on the back line is very small, and it basically depends on the raised side panels, so be careful not to leave too many lines on the back.
There are two 3.5-inch hard disk mounts that are also compatible with 2.5-inch.
The panel part, out of the metal dust-proof net, and no internal dust-proof net, will still make me worry about the problem of a small amount of dust entering the chassis.
Finally, take a look at the framework of the chassis, because I want to install water cooling, the first concern is of course the support of the cold row, the top support 240 cold row, of course, no problem.
In front of the 240 cold platoon meeting and hard disk rack a little conflict, it is recommended that in the upper 120 cold row is better.
Installed below
Configuration
CPU: AMD 860K
Motherboard: Asus A88XM-PLUS
Memory: Genius GENUINE Series DDR3 2400 4GBx2
Graphics: GALAXY GTX 780 Hall of Fame
Heat dissipation: split water-cooled power supply: Zhenhua rated 550W LEADEX G 550 power supply chassis: Xingu aurora blade
Wait for zen. . . . . . .
Motherboard first installed
Cpu, graphics cards are installed on the cold head; placed at the top 240 cold row; placed 120 cold row in front.
Hose access.
The water-cooled liquid is yellow and the overall color scheme is yellow and white.
Some details
Add Iron Egg Elements
light pollution
New Products
SHENZHEN CHONDEKUAI TECHNOLOGY CO.LTD , https://www.szsiheyi.com